Key Responsibilities Key Responsibilities

RTL Design and Verification

Develop synthesizable RTL in Verilog/SystemVerilog for custom on-chip test, monitoring, and diagnostic IP targeting analog and mixed-signal failure detection.
Design and verify digital logic blocks such as test controllers, sequencing logic, sensor/interface control logic, measurement and monitoring logic, data capture and comparison logic, and failure detection and reporting logic.
Build clean register and bus-connected interfaces, for example APB, AHB, or AXI-lite based control and status paths, to enable firmware interaction and subsystem integration.
Develop testbenches, assertions, checkers, and block or subsystem-level verification environments to validate controller behavior, detection logic, configuration programming, fault response, and status reporting.
Plan and execute functional verification for normal, corner, negative, and fault-injection scenarios, with adequate coverage of critical diagnostic behaviors.
Collaborate with analog and mixed-signal designers to create or use behavioral models, stubs, and interface abstractions for realistic verification of failure mechanisms and observability paths.
Debug RTL and simulation issues through waveform analysis, assertion-based checks, root-cause investigation, and close interaction with integration and product teams.
Ensure the RTL is modular, reusable, timing-aware, synthesis-friendly, and scalable for integration across multiple SoC derivatives.

SoC Integration

Integrate custom DFT / diagnostic IP into SoC subsystems and system-level test architecture with proper consideration for clock/reset structure, interrupt handling, and status visibility.
Work closely with SoC integration and DFT teams to ensure compatibility with system test infrastructure, production test flows, diagnostic mechanisms, and firmware control requirements.
Support integration readiness by addressing CDC, reset interactions, timing considerations, low-power implications, and implementation handoff requirements.

Cross-Functional Collaboration

Work closely with digital, analog, and mixed-signal design teams, DFT engineers, SoC architects, and product/test engineering teams throughout the design and validation cycle.
Translate analog or mixed-signal failure modes into robust digital detection logic suitable for on-chip test, screening, and diagnosis.
Contribute to technical discussions on architecture tradeoffs, observability strategy, and practical silicon debug readiness.

Required Qualifications

Bachelor's or Master's degree in Electrical Engineering, Computer Engineering, or a related field, with 5-7 years of relevant experience.
Strong hands-on experience in RTL design using Verilog/SystemVerilog.
Practical experience in RTL verification, simulation, and debugging methodologies.
Solid understanding of ASIC / SoC design flow including coding, simulation, synthesis, and integration.
Good foundation in digital design concepts such as FSM design, datapath design, bus protocols (AXI/AHB/APB), clock-domain handling, reset strategy, and timing considerations.
Experience working in complex SoC environments with cross-functional teams.

Preferred Qualifications

Experience developing control, monitoring, or diagnostic IP associated with analog or mixed-signal subsystems.
Exposure to behavioral modeling or interface definition for analog and mixed-signal verification use cases.
Familiarity with subsystem-level integration, production screening considerations, and silicon debug support.
Working knowledge of scripting or automation for verification, regression, or design productivity is an advantage.

(Sr./Staff) ASIC Design Engineer